简介

How remove the outer casing

  1. Lay device face down on surface.
    • Lay device face down on surface.

  2. Heat the left and top edges with hairdryer for one minute. Move hairdryer back and forth to evenly heat up surface.
    • Heat the left and top edges with hairdryer for one minute.

    • Move hairdryer back and forth to evenly heat up surface.

    • Caution: directly heating the screen can melt or distort the screen.

  3. 所有超过US$100.00或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店

    善于维修,即天赋异禀。

    与 #ImAGenius 分享您的维修故事

    我们都是天才

    与 #ImAGenius 分享您的维修故事

  4. Use tweezers to hold Palm right side down on it's side.
    • Use tweezers to hold Palm right side down on it's side.

    • Use a plastic opening tool to pry open front and back casing.

    • If you are unable to open you may need to heat with hairdryer for longer.

    • Be sure not to touch case directly with fingers, it will be hot!

  5. Leave plastic opening tools in between front and back casing.
    • Leave plastic opening tools in between front and back casing.

    • Rotate Palm and repeat steps 2 and 3 for right and back edges.

  6. Now pry open front and back casing with plastic opening tools. Separate front and back casing completely. Power button will fall off once front and back casing have been removed. Be sure not to lose it.
    • Now pry open front and back casing with plastic opening tools.

    • Separate front and back casing completely.

    • Power button will fall off once front and back casing have been removed. Be sure not to lose it.

终点

Anthony Platt

于2010年02月09日注册

66 信誉积分

创作了3篇指南

团队

Cal Poly, Team 13-25, Maness Winter 2010 Cal Poly, Team 13-25, Maness Winter 2010 的会员

CPSU-MANESS-W10S13G25

4 名成员

创作了4篇指南

So...This given by my grandmother and it is out of battery. Unluckily, it won't charge, because the %#*@ old battery had gone kaput. I had a hard time finding one that might be suitable, and turnout that I need to insert it into the device and connect it to the circuit board. I have some solid soldering skills, but without a heat gun, the andonized cover won't come off. And what's more, I jammed a pencil tip into the "reset" hole when trying to reset the device. Thinking the big opening was a kind of cover-releasing button...I was just having a whole lot of trouble and thinking too much. !&&*.

Xavier Jiang - 回复

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 1,354