简介

Make sure you have a replacement board before starting. Refer to the these sites for replacement parts. http://www.palmmediccanada.com/pm1xx.htm or http://www.directfix.com/category/_PM1.h...

配件

无需配件。

  1. Start with your intact Palm m105.
    • Start with your intact Palm m105.

    添加评论

  2. Remove protective flap by pulling directly out from the top.
    • Remove protective flap by pulling directly out from the top.

    • The two clips will pop out

    添加评论

    • Remove Faceplate. There is a tab where the finger is located in the picture that needs to be pulled up.

    • The Faceplate will then easily lift off

    添加评论

    • Using a T5 Torx bit screwdriver, remove the four screws located on the back of the device turning counter clockwise.

    • The link to purchase this screwdriver is Located here.

    添加评论

    • This is what the device looks like once you have taken the screws out and opened the device.

    添加评论

    • The Motherboard and screen will pop out of the back case easily.

      • Be careful when doing this step, the components are fragile.

    添加评论

    • To remove the screen from the motherboard there are going to be three tabs that need to pulled up.

    • ** This step needs to be done with special care because it is very fragile.**

    • Once they are all three popped up the motherboard and screen will separate easily.

    添加评论

  3. 添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Aaron

于2011年10月04日注册

7 信誉积分

撰写一个指南

团队

UW Stout, Team 1-3, Zhou Fall 2011 UW Stout, Team 1-3, Zhou Fall 2011 的会员

UWSTOUT-ZHOU-F11S1G3

4 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 785