Palm m 100 Cover Replacement - iFixit 维修指南

简介

If the front and/or rear cover is cracked, this guide will teach the user to remove the damaged cover and replace with a new one.

你所需要的

步骤 1 Cover

Palm m 100 Cover Replacement, Cover: 步骤 1 中的图像 1，1

Remove the batteries.

步骤 2

Palm m 100 Cover Replacement: 步骤 2 中的图像 1，1

Using a Torx 5 screwdriver, remove the four screws located on the rear cover of the device by turning counterclockwise. Set aside screws.

步骤 3

Palm m 100 Cover Replacement: 步骤 3 中的图像 1，3

Palm m 100 Cover Replacement: 步骤 3 中的图像 2，3

Palm m 100 Cover Replacement: 步骤 3 中的图像 3，3

Remove rear cover by gently lifting it up from the bottom. To remove the front cover, flip the device over, and then separate the screen/circuit board from the cover.

步骤 4

Palm m 100 Cover Replacement: 步骤 4 中的图像 1，1

Set aside broken cover, and replace with a new cover.

步骤 5

Palm m 100 Cover Replacement: 步骤 5 中的图像 1，1

Close again like a book, and lay it gently into the front panel. Make sure the screen is facing outwards of the front panel.

步骤 6

Palm m 100 Cover Replacement: 步骤 6 中的图像 1，1

Put the back cover on the device and screw the four screws, screwing in a clockwise direction. Take caution not to over-tighten the screws.

结论

To reassemble your device, follow these instructions in reverse order.

作者

与4其他贡献者

Anne Carey

于10/25/11注册

1 声望

创作了3篇指南

团队

James Madison, Team 1-3, Allen Fall 2011 James Madison, Team 1-3, Allen Fall 2011 的会员

JMU-ALLEN-F11S1G3

5 名成员

创作了5篇指南

0条评论

浏览统计数据:

过去 24 小时： 0

过去 7 天： 0

过去 30 天： 0

总计 537