跳转到主内容

简介

This guide will provide instructions and visuals on how to replace a faulty circuit board.

配件

没有特定配件。

    • Remove the batteries.

    • Using a Torx 5 screwdriver, remove the four screws located on the rear cover of the device by turning counterclockwise. Set aside screws.

    • Remove rear cover by gently lifting it up from the bottom.

    • Carefully lift up the circuit board, which will also lift up the screen, so do so carefully to prevent breaking the connectors.

  1. Macbook 电池维修套装

    起价 $69.99

    Buy Now

    Macbook 电池维修套装

    起价 $69.99

    Buy Now
    • Lift the left side of the circuit board and open it as though it were a book.

    • Unplug the three connectors located on the right side of the circuit board with great caution and care. Do not pull by the cable and be sure to pull the connector itself gently.

    • After separating the screen from the board, set aside the faulty circuit board.

    • Replace with a new circuit board

    • Plug in the three connectors.

    • Close again like a book, and lay it gently into the front panel, screen facing outwards of the front panel.

    • Put the back cover on the device and screw the four screws, screwing in a clockwise direction. Take caution not to over-tighten the screws.

结论

To reassemble your device, follow these instructions in reverse order.

Lexi Gallucci

于2011年10月18日注册

11 信誉积分

创作了2篇指南

团队

James Madison, Team 1-3, Allen Fall 2011 James Madison, Team 1-3, Allen Fall 2011 的会员

JMU-ALLEN-F11S1G3

5 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 466