简介

This is a guide that indicates how to replace a faulty microphone for the Palm Treo 680.

  1. Remove the battery cover by pressing on the small rectangular button location the back of the phone.
    • Remove the battery cover by pressing on the small rectangular button location the back of the phone.

    添加评论

  2. Remove the battery by pulling it out toward you.
    • Remove the battery by pulling it out toward you.

    添加评论

    • Unscrew the 0.266 inch top-left screw with a T6 Torx Screwdriver.

    • Be sure to remove the stylus in order to access the screw.

    Use a T5 Torx screwdriver instead of a T6. T6 is too big.

    Rhebakah Thomas - 回复

    I found T5 too large as well. T4 seeems to work

    Absent Minded Professor - 回复

    • Using the spudger, remove the rubber rectangular cover located in the upper right hand side of the device.

    • Unscrew the 0.266 inch screw with the T6 Torx Screwdriver.

      • If there is a red Palm sticker covering the screw, just puncture it to access the screw.

    添加评论

    • Remove the remaining two 0.266 inch screws at the bottom of the device.

    添加评论

    • Turn the phone 90 degrees to the right, so the screen is facing the right side.

    • Use a spudger to carefully separate the back panel from the front panel to access all the various components inside the phone.

    • Separate the covers from the left side of the device as indicated in the picture. The right side contains orange ribbons that are easily damaged.

    添加评论

    • Using a pair of tweezers, grasp the blue rubber microphone.

    • Pull the rubber microphone up and back to remove it.

    • Now you have successfully removed the microphone.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Maiya123

于2009年10月22日注册

51 信誉积分

创作了6篇指南

团队

Cal Poly, Team 6-4, Maness Fall 2009 Cal Poly, Team 6-4, Maness Fall 2009 的会员

CPSU-MANESS-F09S6G4

4 名成员

创作了12篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 2

总计 4,019