简介

A quick guide to replacing the earphone in the palm treo.

  1. Position the phone so the screen faces down.
    • Position the phone so the screen faces down.

    • Remove the stylus found on the back of the phone.

    添加评论

  2. To remove the battery cover, hold down the button in the middle of the phone's back.
    • To remove the battery cover, hold down the button in the middle of the phone's back.

    • Slide the cover down to remove. Set the cover aside.

    添加评论

    • Lift the edge of the battery, separating contact points, and pull out as pictured.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the small round rubber cover on the back of the phone located immediately below the antenna.

    • This will uncover a screw that will be removed in the next step.

    添加评论

    • Unscrew six black 6.9 mm Torx screws with a T5 Torx Screwdriver.

    • Unscrew one 9.75 mm Phillips antenna screw with a Phillips #00 Screwdriver.

    • Pull out antenna.

    添加评论

    • Pry the back cover off using a spudger or similar tool.

    • The back cover is attached by several small clips on the inside.

    添加评论

    • Unclip the gray tab.

    • Pull out the orange ribbon cable.

    • Do not remove the motherboard before disconnecting the ribbon cable--Damage may occur!

    添加评论

    • Pull off the mother board.

    • Install replacement or repaired motherboard, reversing steps above.

    添加评论

    • Pull out the earphone by grabbing the black rubber piece.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

cgood

于2009年10月28日注册

116 信誉积分

创作了7篇指南

团队

Cal Poly, Team 19-3, Maness Fall 2009 Cal Poly, Team 19-3, Maness Fall 2009 的会员

CPSU-MANESS-F09S19G3

4 名成员

创作了18篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 2,790