简介

This guide will help you access and replace the Treo's camera if it is no longer functional.

Position the phone so the screen faces down.
  • Position the phone so the screen faces down.

  • Remove the stylus found on the back of the phone.

添加评论

To remove the battery cover, hold down the button in the middle of the phone's back.
  • To remove the battery cover, hold down the button in the middle of the phone's back.

  • Slide the cover down to remove. Set the cover aside.

添加评论

Lift the edge of the battery, separating contact points, and pull out as pictured. Lift the edge of the battery, separating contact points, and pull out as pictured.
  • Lift the edge of the battery, separating contact points, and pull out as pictured.

添加评论

Remove the small round rubber cover on the back of the phone located immediately below the antenna.
  • Remove the small round rubber cover on the back of the phone located immediately below the antenna.

  • This will uncover a screw that will be removed in the next step.

添加评论

Mac RAM 套件
加速你的Mac。充分利用它的内存。
Mac RAM 套件
从Mac中清理出更多内存。
Unscrew six black 6.9 mm Torx screws with a T5 Torx Screwdriver. Unscrew one 9.75 mm Phillips antenna screw with a Phillips #00 Screwdriver. Pull out antenna.
  • Unscrew six black 6.9 mm Torx screws with a T5 Torx Screwdriver.

  • Unscrew one 9.75 mm Phillips antenna screw with a Phillips #00 Screwdriver.

  • Pull out antenna.

添加评论

Pry the back cover off using a spudger or similar tool. The back cover is attached by several small clips on the inside.
  • Pry the back cover off using a spudger or similar tool.

  • The back cover is attached by several small clips on the inside.

添加评论

Remove the two 3.75 mm screws. Pull off the logic board. Pull off the logic board.
  • Remove the two 3.75 mm screws.

  • Pull off the logic board.

添加评论

Pull the rubber ring off of the camera. Pull the rubber ring off of the camera. Pull the rubber ring off of the camera.
  • Pull the rubber ring off of the camera.

添加评论

Pry off the metal camera case. Lift up the camera, but do not remove. The connector must be detatched first.
  • Pry off the metal camera case.

  • Lift up the camera, but do not remove. The connector must be detatched first.

添加评论

Pry off the camera connector plug. Remove the camera.
  • Pry off the camera connector plug.

  • Remove the camera.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

cgood

于2009年10月28日注册

116 信誉积分

创作了14篇指南

团队

Cal Poly, Team 19-3, Maness Fall 2009 Cal Poly, Team 19-3, Maness Fall 2009 的会员

CPSU-MANESS-F09S19G3

4 名成员

创作了18篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 5

总计 1,958