简介

Steps to follow if you want to replace the logic board. Also needed if you want to access the camera.

On the back of the device, locate the 3 rubber plugs, and use a plastic spudger to remove them.
  • On the back of the device, locate the 3 rubber plugs, and use a plastic spudger to remove them.

添加评论

Use the T6 Torx Screwdriver to remove all 4 screws.
  • Use the T6 Torx Screwdriver to remove all 4 screws.

  • You have to first remove the Stylus to access the 4th screw.

添加评论

  • Using a plastic opening tool, carefully separate the front and back cases.

  • Note: The antenna will detach from the phone.

添加评论

  • Using the Phillips #00 screwdriver, unscrew the 4 screws holding the silver casing down.

添加评论

  • Lift up the silver casing.

  • Careful! The casing is connected to the body. Pull the casing up.

添加评论

  • With the silver casing removed, unscrew two black screws with a #00 Phillips Screwdriver.

添加评论

  • Use the spudger to lift the logic board from its socket. Remove it from the rest of the phone.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Clement Poisson

于2010年01月26日注册

24 信誉积分

创作了7篇指南

团队

Cal Poly, Team 13-23, Maness Winter 2010 Cal Poly, Team 13-23, Maness Winter 2010 的会员

CPSU-MANESS-W10S13G23

4 名成员

创作了16篇指南

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 2

过去的30天: 2

总计 1,406