跳转到主内容

简介

If your camera doesn't work and it needs to be replaced, this guide will come in handy.

  1. On the back of the device, locate the 3 rubber plugs, and use a plastic spudger to remove them.
    • On the back of the device, locate the 3 rubber plugs, and use a plastic spudger to remove them.

  2. Use the T6 Torx Screwdriver to remove all 4 screws. You have to first remove the Stylus to  access the 4th screw.
    • Use the T6 Torx Screwdriver to remove all 4 screws.

    • You have to first remove the Stylus to access the 4th screw.

  3. Using a plastic opening tool, carefully separate the front and back cases. Note: The antenna will detach from the phone.
    • Using a plastic opening tool, carefully separate the front and back cases.

    • Note: The antenna will detach from the phone.

  4. Macbook 电池维修套装

    起价 $69.99

    Buy Now

    Macbook 电池维修套装

    起价 $69.99

    Buy Now
  5. Using the Phillips #00 screwdriver, unscrew the 4 screws holding the silver casing down.
    • Using the Phillips #00 screwdriver, unscrew the 4 screws holding the silver casing down.

  6. Lift up the silver casing.
    • Lift up the silver casing.

    • Careful! The casing is connected to the body. Pull the casing up.

  7. With the silver casing removed, unscrew two black screws with a #00 Phillips Screwdriver.
    • With the silver casing removed, unscrew two black screws with a #00 Phillips Screwdriver.

  8. Use the spudger to lift the logic board from its socket.  Remove it from the rest of the phone. Use the spudger to lift the logic board from its socket.  Remove it from the rest of the phone.
    • Use the spudger to lift the logic board from its socket. Remove it from the rest of the phone.

  9. Using the flat end of the spudger, lift the metal case off of the camera. Using the flat end of the spudger, lift the metal case off of the camera.
    • Using the flat end of the spudger, lift the metal case off of the camera.

  10. Slide the flat end of the spudger between the printed circuit board and metal holder. Pop the camera up Pop the camera up
    • Slide the flat end of the spudger between the printed circuit board and metal holder.

    • Pop the camera up

结论

To reassemble your device, follow these instructions in reverse order.

Clement Poisson

于2010年01月26日注册

24 信誉积分

创作了7篇指南

团队

Cal Poly, Team 13-23, Maness Winter 2010 Cal Poly, Team 13-23, Maness Winter 2010 的会员

CPSU-MANESS-W10S13G23

4 名成员

创作了16篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 1

总计 1,482