简介

Follow this guide to remove and replace your Palm IIIc's motherboard.

配件

无需配件。

Keep track of all pieces removed from the device.
  • Keep track of all pieces removed from the device.

  • Gently pull off the device cover. The cover snaps on and off easily where the cover attaches to the Palm IIIc device

添加评论

Using a Phillips head screw driver, take out the four screws on the back of the device. You may have to pull them out with your hands once they are unscrewed.
  • Using a Phillips head screw driver, take out the four screws on the back of the device. You may have to pull them out with your hands once they are unscrewed.

  • There will be two long screws and two short screws. The long screws come from the top of the device, and the short screws come from the bottom of the device.

添加评论

  • Using a spudger, carefully pry open the front and back covers along the side seam.

  • A small sensor cover will fall out when the front and back covers are removed. Keep track of it.

添加评论

  • Screen-side down, unhook the battery cable from the motherboard.

添加评论

  • Unhook the blue and red screen cables.

添加评论

  • On the back of the motherboard near the top, gently lift up the flap that holds the ZIF connector tab in place. This will allow you to pull out the ZIF connector tab.

添加评论

  • Located near the bottom of the motherboard will be two ZIF connector tabs. Gently lift up the flap that secures these tabs and remove the tabs.

添加评论

  • Gently bend back the black clips that secure the motherboard.

  • Remove the motherboard starting from the left side and pull it out away from the clips.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Paulina Trujillo

于2011年04月07日注册

241 信誉积分

创作了9篇指南

团队

Cal Poly, Team 20-69, Walters Spring 2011 Cal Poly, Team 20-69, Walters Spring 2011 的会员

CPSU-WALTERS-S11S20G69

5 名成员

创作了9篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 2

总计 1,003