简介

Steps for replacing malfunctioned directional pads in a Sony PSP-3000

Place the PSP face down and locate the battery cover on the left side of the device.
  • Place the PSP face down and locate the battery cover on the left side of the device.

  • Lift and remove the battery cover to reveal the battery.

  • Remove the battery.

添加评论

Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.
  • Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.

添加评论

  • Unscrew all four screws from the back of the PSP with the Phillips #00 Screwdriver.

    • Two are located behind the battery's warranty sticker.

    • Two are located on the right side of the PSP.

添加评论

  • Next, unscrew the two screws located at the top of the PSP.

添加评论

  • Then, remove the single screw from the bottom edge of the PSP (which is positioned next to the barcode).

添加评论

  • Slide the spudger in between the outer casing of the PSP, beginning at the "R" shoulder button, and gently pry off the casing.


  • Remove the front casing completely.

添加评论

  • Peal up the rubber pad that is securing the D-pad buttons to the backside of the front casing.

  • Remove the D-pad and the rubber piece.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

3等其他人完成本指南。

mbnewsom

于2009年10月28日注册

2,372 信誉积分

创作了11篇指南

Is it for 2000?

Kaio Igor - 回复

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 5

过去的30天: 42

总计 5,655