简介

This guide will take you through all the steps to sucessfully install a new logic board to your Olympus D590 camera.

配件

无需配件。

  1. Flip camera so you are looking at the bottom.
    • Flip camera so you are looking at the bottom.

    • Unscrew all 5 base plate screws.

  2. Lift open retainer clip by sliding the clip to the left and letting the clip pop up.
    • Lift open retainer clip by sliding the clip to the left and letting the clip pop up.

  3. Unscrew the single screw located next to the battery slot.
    • Unscrew the single screw located next to the battery slot.

  4. Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.
    • Turn the camera so that the USB, AV and DC in/out rubber plate it facing you.

    • Lift the rubber plate exposing the ports beneath.

  5. 所有超过US$100.00或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店

    善于维修,即天赋异禀。

    与 #ImAGenius 分享您的维修故事

    我们都是天才

    与 #ImAGenius 分享您的维修故事

  6. Unscrew the 2 screws next to the USB and AC ports.
    • Unscrew the 2 screws next to the USB and AC ports.

  7. Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.
    • Use a flathead screwdriver or another flat opening tool to pry the faceplate from the whole device.

  8. Pull off the faceplate to reveal the inside of the camera.
    • Pull off the faceplate to reveal the inside of the camera.

    • Be careful of the connector that goes from the faceplate to the motherboard . Disconnecting this line will cause the camera not not power on through the on/off switch anymore.

  9. Unscrew all 4 circled screws.
    • Unscrew all 4 circled screws.

  10. The logic board should now be loose and easily liftable.
    • The logic board should now be loose and easily liftable.

    • DO NOT lift the board out completely the wiring that is still connected must be disconnected before proceeding.

  11. Disconnect the 3 wiring strips from the device by gently pulling with tweasers from the base of the strip. Do not use sharp tweasers because the wiring might tear. Make sure to use small force so the wiring is not damaged.  It may help to gently wiggle the tape.
    • Disconnect the 3 wiring strips from the device by gently pulling with tweasers from the base of the strip.

    • Do not use sharp tweasers because the wiring might tear.

    • Make sure to use small force so the wiring is not damaged. It may help to gently wiggle the tape.

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Sara

于2010年04月15日注册

84 信誉积分

创作了2篇指南

团队

Cal Poly, Team 28-23, Regan Spring 2010 Cal Poly, Team 28-23, Regan Spring 2010 的会员

CPSU-REGAN-S10S28G23

4 名成员

创作了7篇指南

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 1,612