简介

Follow this guide if you need to replace the camera on a Nokia Lumia 930 smartphone.

Pull the sim card holder and the sim card out of the top of the phone using your fingernail.
  • Pull the sim card holder and the sim card out of the top of the phone using your fingernail.

添加评论

Place the tweezers in the sim card hole and upwards until the back panel pops out.
  • Place the tweezers in the sim card hole and upwards until the back panel pops out.

添加评论

  • Wedge a plastic opening tool into the opening made in the previous step. Slide it along the edges to completely remove the back panel from the phone’s frame.

添加评论

  • Remove the single 4mm Torx #4 screw that's securing the battery strap to the phone.

添加评论

  • Use the tweezers to remove the battery connector strap.

添加评论

  • Remove the ten 4mm Torx #4 screws that secure the battery cover to the frame of the phone.

添加评论

  • Use the flat end of the spudger to pry the battery cover apart from the phone frame.

添加评论

  • Pull up on the heat spreader, being careful not to tear it.

添加评论

  • Use the flat end of the spudger to lift up the battery.

  • The batter is glued in place so pry carefully to not damage it.

  • Two flex cables are directly underneath the battery.

添加评论

  • Pull up to remove the battery from the phone.

添加评论

  • Use the flat end of a spudger to disconnect the camera connectors.

  • Pull the camera up and out to remove it from the phone.

添加评论

  • Use the flat end of a spudger to disconnect the six ribbon cables from the motherboard.

添加评论

  • Take the flat end of a spudger to pry up the orange flex found under the battery.

  • Remove the orange flex cable from the phone.

添加评论

  • Do the same as mentioned previously but for the the black Jumper flex that is also found under the batter.

添加评论

  • Use the flat end of a spudger to disconnect the antenna cable from the motherboard.

  • Remove the antenna cable.

添加评论

  • Grab the LTE adhesive that is under the LTE flex and pull it outwards towards the bottom end of the phone.

    • Apply new adhesive when reassembling the phone.

添加评论

  • Use a spudger to pry up the bottom end of the motherboard so you can pull it out.

添加评论

  • Use the flat edge of a spudger to disconnect the camera.

  • Remove the camera.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

calvin

于2018年02月21日注册

73 信誉积分

撰写一个指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 8

总计 59