简介

How to remove the circuit board.

配件

无需配件。

Turn off the cell phone.
  • Turn off the cell phone.

添加评论

Press down on the round button on the back cover of the phone.
  • Press down on the round button on the back cover of the phone.

添加评论

  • Slide the back cover down while still pressing the button.

添加评论

  • Remove the back cover.

添加评论

  • Press the end of the battery towards the top of the phone.

添加评论

  • Lift the battery outwards while still pressing it upwards till it pops out.

  • You may need to take several attempts to lift out the battery.

添加评论

  • Squeeze the flat end of the spudger into the crack right under the word "Nokia" on the back of the phone.

  • This step may be a bit difficult if you are removing the antenna for the first time.

添加评论

  • Pry open the antenna door by pulling down the top of the spudger

添加评论

  • Remove the antenna door.

添加评论

  • If the gold antenna remained stuck to the door, you have finished removing the antenna from the phone.

  • If the gold antenna is still in the phone, carefully remove it and stick it onto the back of the door.

  • Try to keep the antenna as flat as possible. Do not bend it.

添加评论

  • Remove the five screws with the Torx Screwdriver: two near the bottom, two in the middle, and one under the antenna door.

  • The two bottom screws are longer than the upper three.

添加评论

  • Remove the back covering.

添加评论

  • Remove the two screws at the top.

添加评论

  • Remove the metal plating and the circuit board.

  • There is nothing holding the rest of the phone together. Handle the rest of the phone carefully.

  • The LCD will be attached to the circuit board.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Aaron Jen

于2010年04月11日注册

1 信誉积分

创作了7篇指南

团队

Cal Poly, Team 27-94, Amido Spring 2010 Cal Poly, Team 27-94, Amido Spring 2010 的会员

CPSU-AMIDO-S10S27G94

4 名成员

创作了14篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 1

总计 2,618