配件

无需配件。

Place your thumb on the middle of the back cover and push it toward the bottom of the phone to slide the cover off. Place your thumb on the middle of the back cover and push it toward the bottom of the phone to slide the cover off. Place your thumb on the middle of the back cover and push it toward the bottom of the phone to slide the cover off.
  • Place your thumb on the middle of the back cover and push it toward the bottom of the phone to slide the cover off.

添加评论

Use a plastic opening tool (or your finger) to gently pry the battery out of the battery slot on the back of the phone. Use a plastic opening tool (or your finger) to gently pry the battery out of the battery slot on the back of the phone. Use a plastic opening tool (or your finger) to gently pry the battery out of the battery slot on the back of the phone.
  • Use a plastic opening tool (or your finger) to gently pry the battery out of the battery slot on the back of the phone.

添加评论

Lift the metal sim card holder (at the bottom of the battery slot) up and carefully pry the sim card out of its slot with a plastic opening tool or your finger. After removal, lower the metal sim card holder into its original position. After removal, lower the metal sim card holder into its original position.
  • Lift the metal sim card holder (at the bottom of the battery slot) up and carefully pry the sim card out of its slot with a plastic opening tool or your finger.

  • After removal, lower the metal sim card holder into its original position.

添加评论

Insert the plastic opening tool into the crack between the front and back panels. Gently pry the front cover away from the back cover while sliding the plastic opening tool towards the top of the phone.
  • Insert the plastic opening tool into the crack between the front and back panels.

  • Gently pry the front cover away from the back cover while sliding the plastic opening tool towards the top of the phone.

添加评论

Lift the bottom of the front cover away from the phone. Continue lifting until the top of the front cover is fully removed from the phone.
  • Lift the bottom of the front cover away from the phone.

  • Continue lifting until the top of the front cover is fully removed from the phone.

  • Note: To replace the Keypad, gently lift it out of the front cover. It is located below the clear viewing window.

添加评论

Use the Torx screwdriver with the T6 attachmet  to remove the 6 .4 mm screws around the outside of the circuit board.
  • Use the Torx screwdriver with the T6 attachmet to remove the 6 .4 mm screws around the outside of the circuit board.

  • Note: Removing the 4 T6 screws around the screen will loosen it, so don't worry if the screen also separates from the circuit board.

添加评论

Lift the circuit board out of the back cover. Lift the circuit board out of the back cover. Lift the circuit board out of the back cover.
  • Lift the circuit board out of the back cover.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

5等其他人完成本指南。

Andrew Wood

于2010年10月05日注册

321 信誉积分

创作了6篇指南

团队

Cal Poly, Team 7-52, Amido Fall 2010 Cal Poly, Team 7-52, Amido Fall 2010 的会员

CPSU-AMIDO-F10S7G52

4 名成员

创作了12篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 3

过去的30天: 8

总计 2,810