跳转到主内容

简介

Use this guide to replace the power board on your Nintendo Wii mini.

  1. Turn the Wii mini upside down. Remove the two rubber feet at the back of the console to reveal the hidden screws.
    • Turn the Wii mini upside down.

    • Remove the two rubber feet at the back of the console to reveal the hidden screws.

    • Remove the four 6mm Phillips #0 screws.

  2. Turn the Wii mini right-side up. Run a plastic opening tool around the middle edge of the console to loosen the top piece. Gently lift the top piece of the console and set it aside.
    • Turn the Wii mini right-side up.

    • Run a plastic opening tool around the middle edge of the console to loosen the top piece.

    • Gently lift the top piece of the console and set it aside.

  3. Using your fingers, slide out the blue ribbon cable from the the top of the power board. Using a Phillips #0 Screwdriver, unscrew the two 4mm screws at  the top and bottom of the power  board. Using a Phillips #0 Screwdriver, unscrew the two 4mm screws at  the top and bottom of the power  board.
    • Using your fingers, slide out the blue ribbon cable from the the top of the power board.

    • Using a Phillips #0 Screwdriver, unscrew the two 4mm screws at the top and bottom of the power board.

  4. Using your fingers, gently pull the pin connector to disconnect the power board from the disc drive. Using your fingers, gently pull the pin connector to disconnect the power board from the disc drive.
    • Using your fingers, gently pull the pin connector to disconnect the power board from the disc drive.

  5. Lift the power board from the console and set it aside. Lift the power board from the console and set it aside.
    • Lift the power board from the console and set it aside.

结论

To reassemble your device, follow these instructions in reverse order.

Kristin Anderson

于2015年01月23日注册

741 信誉积分

创作了5篇指南

团队

UWT Liner: Group 5 UWT Liner: Group 5 的会员

Community

3 名成员

创作了10篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 9

总计 1,100