简介
For clarification, the trackpads and the directional pad are not the same. This guide is for replacing the rubber pads below the buttons, not the buttons themselves.
-
-
Use a standard Phillips #00 screwdriver to loosen the 4mm screw that keeps the battery cover attached to the device.
-
-
-
Using the tri-wing screwdriver, unscrew the screws holding the back cover to the device. The six screws that need to be removed include:
-
Four #00 6.45mm tri-wing screws that are located at the corners of the device.
-
Two #00 4.6mm tri-wing screws that are located at the top-center and bottom-center of the device.
-
-
-
Using a Phillips #00 screwdriver, remove the three Phillips #00 4 mm long screws that hold the motherboard to the button panel.
-
-
-
Using your fingers, gently lift and remove the trackpads covering the following:
-
'A' and 'B' buttons
-
Directional Control Button Pad
-
'Start' and 'Select' buttons
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
5等其他人完成本指南。