简介

Replace your DSi XL's speakers so you can hear Mario yell "Mamma mia" as clear as ever.

Remove the two Phillips screws securing the battery cover to the back of the handheld console.
  • Remove the two Phillips screws securing the battery cover to the back of the handheld console.

  • Lift the battery cover off the back of the DSi XL.

添加评论

Lift the battery from the DSi XL.
  • Lift the battery from the DSi XL.

添加评论

  • Use a push pin to remove the four plastic screw covers on the front bezel.

添加评论

  • Remove four Phillips screws securing the front bezel to the rear bezel.

添加评论

  • Using two hands, gently slide the rear bezel upwards.

  • The rear bezel will move only about 2 mm.

添加评论

  • Insert a spudger into the gap between the front and rear bezel

  • Rotate the spudger away from the DSi XL, prying the two bezels apart.

添加评论

  • In the same manner as described above, continue prying along the top edge of the front and rear bezels.

添加评论

  • Separate the rear bezel from the front bezel.

  • Do not attempt to completely remove the rear bezel yet. It is still attached to the front bezel by the rear-facing camera.

添加评论

  • Use the flat end of a spudger to pry the rear camera off the rear bezel.

  • Remove the rear bezel.

添加评论

  • Use a spudger to lift the antenna from the front bezel to make room for lifting the speaker cables up.

添加评论

  • Use a spudger to lift the right speaker from its housing in the front bezel.

添加评论

  • Use a spudger to lift the left speaker from its housing in the front bezel.

添加评论

  • De-route the left speaker cable along the top edge of the upper LCD.

添加评论

  • Open the display slightly, and lift the LCD out of the front bezel.

  • Lay the LCD down next to the DSi XL.

  • Don't attempt to remove the LCD, it is still attached to the front bezel via the display data ribbon cable.

添加评论

  • Desolder the two solder joints to separate the speakers from the LCD.

    • Right Speaker

    • Left Speaker

  • For both speakers, the red wire (positive lead) is soldered to the left contact. The black wire (negative lead) is soldered to the right contact point.

  • For detailed instructions on how to solder this type of connection, see our guide for repairing soldered connections.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Matthew Newsom

于2010年01月05日注册

31,792 信誉积分

创作了67篇指南

Thank you for this video but I need some more help cause I dont know if my problem are the speakers or the earphones jack how can I solve this just one clue i need thanks again

Josh - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 6

总计 5,405