简介

Removing the back panel is simple, provided you have the correct screwdriver. Nintendo uses a special Tri-wing bit for the case, be sure you have one of these before disassembling!

Remove the cartridge from the console. Use a Phillips #00 Screwdriver to remove the screw securing the battery door to the rear case, turning the screw counter-clockwise. Remove the battery door.
  • Remove the cartridge from the console.

  • Use a Phillips #00 Screwdriver to remove the screw securing the battery door to the rear case, turning the screw counter-clockwise.

  • Remove the battery door.

添加评论

Use a plastic opening tool or spudger to pry out the battery from the bottom. If a plastic open tool or spudger isn't available, your fingernails may work.
  • Use a plastic opening tool or spudger to pry out the battery from the bottom. If a plastic open tool or spudger isn't available, your fingernails may work.

添加评论

Mac RAM 套件
加速你的Mac。充分利用它的内存。
Mac RAM 套件
从Mac中清理出更多内存。
Remove the battery from the Nintendo DS.
  • Remove the battery from the Nintendo DS.

添加评论

Remove the 7 Y0 screws located on the back.
  • Remove the 7 Y0 screws located on the back.

  • It might be helpful to remove the strap from the hole to access the top left screw.

添加评论

With your hands, pry the back panel off the main case. Separate the back from the front, and set it aside. Separate the back from the front, and set it aside.
  • With your hands, pry the back panel off the main case.

  • Separate the back from the front, and set it aside.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

7等其他人完成本指南。

dnguye26

于2009年10月28日注册

314 信誉积分

创作了8篇指南

团队

Cal Poly, Team 18-3, Maness Fall 2009 Cal Poly, Team 18-3, Maness Fall 2009 的会员

CPSU-MANESS-F09S18G3

4 名成员

创作了10篇指南

Where do I get a nintendo DS gamepak?

Kayla Maison - 回复

添加评论

浏览统计数据:

过去的24小时: 3

过去的7天: 19

过去的30天: 49

总计 12,088