简介

This is how you remove the bottom cover

Remove the expansion pack cover by pushing in the tab and pulling out.
  • Remove the expansion pack cover by pushing in the tab and pulling out.

添加评论

If your system uses a jumper pack, the same procedure applies to remove it.
  • If your system uses a jumper pack, the same procedure applies to remove it.

  • A small spoon can be used in place of a spudger.

  • Lever the expansion pack out using a metal spudger.

添加评论

  • Remove the six screws on the bottom side indicated in the example with a gamebit head or screwdriver.

添加评论

  • Remove the two front feet of the N64.

添加评论

  • Rotate to top side up and lift off top cover.

添加评论

  • Remove the fourteen screws indicated in the example using the larger Phillips screwdriver.

I’m not entirely certain if it's a common difference, but my nintendo 64 doesn’t have fourteen screws, but rather, 8 screws, and instead of 3 heat sinks, it only has the one separate heat sink on the chip close to the memory expansion pack. additionally, aside from the 6 screws closest to the expansion pack, the two other screws are held on by nuts under the metal piece.

Avery Duncan - 回复

  • Remove the metal plate indicated in the example by sliding it back and then lifting it up.

添加评论

  • Remove the two screws indicated in the example using the smaller Phillips screwdriver.

添加评论

  • Remove the screw to the right of the LED light using the larger Phillips screwdriver.

添加评论

  • Remove the small metal bracket from the back of the expansion pack slot.

添加评论

  • Remove the small metal bracket from the front of the expansion pack slot with the metal spudger.

添加评论

  • Remove the small metal bracket behind the expansion slot using the spudger.

添加评论

  • Remove the seven screws indicated in the example using the larger Phillips screwdriver.

添加评论

  • Lift off and remove the metal plate as indicated in the example.

添加评论

  • Remove the four screws indicated using the #1 Phillips screwdriver.

添加评论

  • Lift up and remove the motherboard.

添加评论

  • Remove everything from the bottom cover.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

11等其他人完成本指南。

tonymag28

于2009年10月28日注册

1,623 信誉积分

创作了3篇指南

团队

Cal Poly, Team 5-4, Regan Fall 2009 Cal Poly, Team 5-4, Regan Fall 2009 的会员

CPSU-REGAN-F09S5G4

7 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 6

过去的7天: 65

过去的30天: 369

总计 16,729