简介

If there is a power problem, you may need to reattach wires to the battery compartment or replace it completely. If the problem is Corrosion, just see the guide on corrosion.

  • In this guide we will be referring to 'left' and 'right' as though the camera's front (the part that says Nikon) is facing you.

  • Unscrew the large metal screw on the left side using a quarter and remove the battery cover.(Picture not available)

添加评论

Use a 00 Phillips head screwdriver to remove the small screw on the far left of the battery compartment.
  • Use a 00 Phillips head screwdriver to remove the small screw on the far left of the battery compartment.

添加评论

  • Pull up on the tab to remove the batteries.

  • Note: The batteries will probably fall out of their holder.

添加评论

  • Use a 00 Phillips head screwdriver to remove the four screws from inside the case.

添加评论

  • Remove the battery compartment from the camera.

  • Note: On some models, the compartment is soldered in by the wires shown. If so you will need to desolder them.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Zachary Phillips

于2011年04月08日注册

205 信誉积分

创作了5篇指南

团队

Cal Poly, Team 25-26, Garner Spring 2011 Cal Poly, Team 25-26, Garner Spring 2011 的会员

CPSU-GARNER-S11S25G26

3 名成员

创作了6篇指南

Hey, i lost the bracket… do u guys have any idea where could i get one?

David mate - 回复

添加评论

浏览统计数据:

过去的24小时: 2

过去的7天: 17

过去的30天: 87

总计 9,585