修复你的物品 社区 商店

Nikon D90 Rear Case Replacement

你所需要的

  1. Nikon D90 Rear Case Replacement, Rear Case: 步骤 1 中的图像 1，2 Nikon D90 Rear Case Replacement, Rear Case: 步骤 1 中的图像 2，2

    • Slide the eyepiece up and off the viewfinder.

    编辑

  2. Nikon D90 Rear Case Replacement: 步骤 2 中的图像 1，1

    • Using a PH000 screwdriver, remove the two 4.8mm Phillips screws from the back of the viewfinder.

    • Some screws may be JIS. Be wary of this if your PH000 does not feel like it is properly gripping the screws.

    编辑

  3. Nikon D90 Rear Case Replacement: 步骤 3 中的图像 1，1

    • Remove the two 6.4mm Phillips screws on the right side of the camera, near the SD card slot.

    编辑

  4. Nikon D90 Rear Case Replacement: 步骤 4 中的图像 1，1

    • Remove the two 6.4mm Phillips screws on the left side of the camera, near the I/O ports.

    编辑

  6. Nikon D90 Rear Case Replacement: 步骤 5 中的图像 1，1

    • On the bottom of the camera,

    • remove the two 5.3mm Phillips screws

    • and the other two 6.3mm Phillips screws.

    编辑

  7. Nikon D90 Rear Case Replacement: 步骤 6 中的图像 1，3 Nikon D90 Rear Case Replacement: 步骤 6 中的图像 2，3 Nikon D90 Rear Case Replacement: 步骤 6 中的图像 3，3

    • Using a spudger, separate the bottom panel from the rear case just enough to clear the two clips on the rear casing in the next step.

    编辑

  8. Nikon D90 Rear Case Replacement: 步骤 7 中的图像 1，2 Nikon D90 Rear Case Replacement: 步骤 7 中的图像 2，2

    • Lift the rear case off of the back of the camera.

    • Don't pull the casing completely off yet, as the ribbon cables are still connected.

    • Be mindful of the two clips, making sure to keep the bottom panel far enough away to clear them.

    编辑

  9. Nikon D90 Rear Case Replacement: 步骤 8 中的图像 1，1

    • Set the rear casing off to the side so you can access the ZIF connectors.

    • The orientation shown in the picture seems to be the best position for the casing to sit comfortably without stressing the ribbon cable connections.

    编辑

  10. Nikon D90 Rear Case Replacement: 步骤 9 中的图像 1，3 Nikon D90 Rear Case Replacement: 步骤 9 中的图像 2，3 Nikon D90 Rear Case Replacement: 步骤 9 中的图像 3，3

    • Use a spudger to lift the black tab on the ZIF connector.

    • Disconnect the ribbon cables from their respective ZIF connectors on the logic board.

    编辑

  11. Nikon D90 Rear Case Replacement: 步骤 10 中的图像 1，1

    • Separate the rear casing from the camera.

    编辑
结论

To reassemble your device, follow these instructions in reverse order.

8等其他人完成本指南。

作者

与7其他贡献者

Ryan Lutz

于09/27/11注册

3,008 声望

创作了3篇指南

徽章: 32

+ 29更多徽章

2条评论

good guidance,easy to follow,thanks

ramalingeswarao kaza - 回复

I want to replace my Nikon D90 DSLR bad LCD, this guide will save me from costly repairs.

ramalingeswarao kaza - 回复

添加评论

浏览统计数据:

过去 24 小时： 1

过去 7 天： 5

过去 30 天： 19

总计 4,198