简介

This guide shows how to remove a broken internal component for navigation buttons.

  1. Place the camera facing upwards.
    • Place the camera facing upwards.

    • Press down on the battery cover and slide towards the front face of the camera.

  2. Rotate the orange battery clip in the camera to release the battery.
    • Rotate the orange battery clip in the camera to release the battery.

  3. Locate the eight outer PH 2mm screws on the device. Using the PH00 screwdriver remove all of the screws from the camera. Using the PH00 screwdriver remove all of the screws from the camera.
    • Locate the eight outer PH 2mm screws on the device.

    • Using the PH00 screwdriver remove all of the screws from the camera.

  4. 所有超过US$100或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  5. Using a plastic opening tool, gently pry off the front and rear plates. Be patient  with this step, do not force the clips holding the plates together. Be patient  with this step, do not force the clips holding the plates together.
    • Using a plastic opening tool, gently pry off the front and rear plates.

    • Be patient with this step, do not force the clips holding the plates together.

  6. Using a Phillips #00 screwdriver, remove the PH 2mm screw located to the right of the screen, above the OK dial.
    • Using a Phillips #00 screwdriver, remove the PH 2mm screw located to the right of the screen, above the OK dial.

  7. Remove the two clasp using a plastic spudger
    • Remove the two clasp using a plastic spudger

    • Be careful when removing the clasp to prevent ripping of the clasp

  8. You may now remove the internal panel of the buttons
    • You may now remove the internal panel of the buttons

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Michael Lynch

于2015年08月31日注册

384 信誉积分

创作了3篇指南

团队

USF Tampa, Team 1-2, Remmell Fall 2015 USF Tampa, Team 1-2, Remmell Fall 2015 的会员

USFT-REMMELL-F15S1G2

5 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 2

过去的30天: 6

总计 418