简介

In this guide, we will give you step-by-step instructions on how to detach the LCD screen so that it can be replaced or repaired.

配件

无需配件。

  1. Remove the memory stick from the camera.
    • Remove the memory stick from the camera.

    • Remove the batteries from the camera.

    添加评论

  2. Remove all six 4.3mm silver screws along the perimeter of the camera using the Phillips #00 screwdriver.
    • Remove all six 4.3mm silver screws along the perimeter of the camera using the Phillips #00 screwdriver.

    • There is one screw hidden under the AV cover that also needs to be removed.

    添加评论

    • Pry the back cover from the left side of the camera. Remove the cover gently.

    添加评论

    • CAUTION! This is where energy for the flash is stored. Even with batteries removed, if you touch these connections, you can be shocked, depending on if the flash capacitor has a stored charge. It may not have a stored charge, but work around this assuming it does.

    • Newer cameras of descent quality usually have a bleeder resistor to drain the flash capacitor. This may not work anymore and the flash capacitor may still have a charge.

    添加评论

    • Remove the tape on the right side of the LCD screen.

    • Gently lift the LCD screen from its base.

    • Don't tug on the screen because it is still connected to the logic board.

    Be very careful not to touch the flash capacitor on far left when lifting the LCD!! It WILL shock you.

    Mark Fraylick - 回复

    Getting the LCD ribbon back "in" is my problem -- hints or suggestions?

    richardkujawa - 回复

    I can't get a feel for how the black clip holds the ribbon - insert the new one at an angle?

    richardkujawa - 回复

    I practiced a few times with the "bad screen" and managed to figure this out. Unfortunately I can't explain how I did it... if some other person can explain how to make the ribbon connection/clip re-install more predictable I think it'd help anyone else who tries the repair.

    richardkujawa - 回复

    • Lift the black latch connecting the LCD ribbon to the logic board.

    • Gently pull the LCD ribbon out.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

7等其他人完成本指南。

Nonny

于2010年10月11日注册

207 信誉积分

创作了2篇指南

团队

Cal Poly, Team 9-23, Regan Fall 2010 Cal Poly, Team 9-23, Regan Fall 2010 的会员

CPSU-REGAN-F10S9G23

4 名成员

创作了5篇指南

Good work! Appreciate it.

Oasis World - 回复

I need a new LCD screen replacement. A link to buy a new one?

William Pullman - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 8

总计 6,628