Skip to main content

介绍

In order to reach the internal elements of the camera (lens, flashbulb, etc.), the following steps will tell you how to remove the front cover.

配件

没有特定配件。

  1. Remove the memory stick from the camera.
    • Remove the memory stick from the camera.

    • Remove the batteries from the camera.

  2. Remove all six 4.3mm silver screws along the perimeter of the camera using the Phillips #00 screwdriver. There is one screw hidden under the AV cover that also needs to be removed.
    • Remove all six 4.3mm silver screws along the perimeter of the camera using the Phillips #00 screwdriver.

    • There is one screw hidden under the AV cover that also needs to be removed.

  3. Pry the back cover from the left side of the camera. Remove the cover gently.
    • Pry the back cover from the left side of the camera. Remove the cover gently.

  4. Android 维修工具包

    一个新的屏幕或电池就在一个套件之内。

    现在开始购物

    Android 维修工具包

    一个新的屏幕或电池就在一个套件之内。

    现在开始购物
  5. CAUTION! This is where energy for the flash is stored.  Even with batteries removed, if you touch these connections, you can be shocked, depending on if the flash capacitor has a stored charge. It may not have a stored charge, but work around this assuming it does.
    • CAUTION! This is where energy for the flash is stored. Even with batteries removed, if you touch these connections, you can be shocked, depending on if the flash capacitor has a stored charge. It may not have a stored charge, but work around this assuming it does.

    • Newer cameras of descent quality usually have a bleeder resistor to drain the flash capacitor. This may not work anymore and the flash capacitor may still have a charge.

  6. Remove the tape on the right side of the LCD screen.
    • Remove the tape on the right side of the LCD screen.

    • Gently lift the LCD screen from its base.

    • Don't tug on the screen because it is still connected to the logic board.

  7. Lift the black latch connecting the LCD ribbon to the logic board.
    • Lift the black latch connecting the LCD ribbon to the logic board.

    • Gently pull the LCD ribbon out.

  8. Pry back the front cover of the camera starting from the right side.
    • Pry back the front cover of the camera starting from the right side.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Andrea Govea

于2010年10月11日注册

357 Reputation

创作了2篇指南

Team

Cal Poly, Team 9-23, Regan Fall 2010 Cal Poly, Team 9-23, Regan Fall 2010 的会员

CPSU-REGAN-F10S9G23

4 名成员

创作了5篇指南

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 2,957