Skip to main content

介绍

This guide provides instruction for safely exposing the LCD screen and internal guts of the Nikon Coolpix AW130.

配件

没有特定配件。

  1. Using your thumb and pointer finger, open the card/battery hatch by pressing the center button of the wheel and turning the entire wheel to the left. When reassembling, you must turn this wheel to the right until it clicks.
    • Using your thumb and pointer finger, open the card/battery hatch by pressing the center button of the wheel and turning the entire wheel to the left.

    • When reassembling, you must turn this wheel to the right until it clicks.

  2. You should feel the door begin to loosen. Carefully pull the hatch open. You should feel the door begin to loosen. Carefully pull the hatch open.
    • You should feel the door begin to loosen. Carefully pull the hatch open.

  3. Push the yellow battery/charger compartment tab up using your thumb nail.
    • Push the yellow battery/charger compartment tab up using your thumb nail.

  4. Android 维修工具包

    一个新的屏幕或电池就在一个套件之内。

    现在开始购物

    Android 维修工具包

    一个新的屏幕或电池就在一个套件之内。

    现在开始购物
  5. After pressing the yellow tab, the battery should loosen. Slowly pull the battery completely out.
    • After pressing the yellow tab, the battery should loosen.

    • Slowly pull the battery completely out.

  6. Using the T5 Torx screwdriver, remove all four 4mm screws. Using the T5 Torx screwdriver, remove all four 4mm screws.
    • Using the T5 Torx screwdriver, remove all four 4mm screws.

  7. Using a Phillips #000 screwdriver, remove the single 3mm screw found inside the battery/charging compartment.
    • Using a Phillips #000 screwdriver, remove the single 3mm screw found inside the battery/charging compartment.

  8. Remove the upper cover (connected by glue) and unscrew the single Philips screw.
    • Remove the upper cover (connected by glue) and unscrew the single Philips screw.

  9. Remove two Philips screws from the bottom cover, lift gently the cover and remove the single Philips screw under it. Remove two Philips screws from the bottom cover, lift gently the cover and remove the single Philips screw under it.
    • Remove two Philips screws from the bottom cover, lift gently the cover and remove the single Philips screw under it.

  10. Carefully remove the back cover from the camera body.
    • Carefully remove the back cover from the camera body.

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Lauren Stepp

于2016年01月29日注册

1,149 Reputation

创作了8篇指南

2 Comments

Did this to inspect the inside of the zoom lever, which is broken and will (only with difficulty) zoom in, and won't (at all) zoom out.

Followed the instructions to the letter but, after all screws removed, was unable to get the back panel separated from the body of the camera. Either there is glue, or some sort of latching mechanism present - or something missing in the description. Didn't want to break anything completely, as camera is still just about usable - so I gave up. I don't think the camera will be water-proof any more after this.

Jason Wolfe - 回复

Does anyone know where I can order an Coolpix AW130 rear panel?

Joel Dean - 回复

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 7

Past 30 Days: 21

All Time: 1,591