简介

Use this guide to replace the LCD.

配件

无需配件。

Remove the four 3.0mm screws on the bottom of the camera.
  • Remove the four 3.0mm screws on the bottom of the camera.

添加评论

Remove the two 3.0mm screws on the left side of the camera near the memory card compartment.
  • Remove the two 3.0mm screws on the left side of the camera near the memory card compartment.

添加评论

  • Remove the two 3.0mm screws on the right side of the camera.

添加评论

  • Carefully open the back cover. Take care as there are connectors still attached.

添加评论

  • Disconnect the cable by pulling the head upward along the green circuit board. If you only are changing the LCD, skip this step.

添加评论

  • Disconnect the ribbon cable by grabbing the two handles and pulling it directly out of the socket. If you are only changing LCD, skip this step.

  • The back cover will be disconnected from the camera

添加评论

  • First remove the three 2.5mm screws securing the LCD screen to the substrate. Make sure not to keep hold of the little metal connector by the top left screw!

  • Carefully flip the screen down to reveal the back of the screen

添加评论

  • Disconnect the ribbon cable and gray connector with red and black wires.

  • Depending on your spare part, you may now need to carefully pry the screen back cover off. It is held by a double sided sticky tape on the inside. Be gentle!

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Kaky Payne

于2012年04月17日注册

58 信誉积分

创作了5篇指南

团队

Cal Poly, Team 12-38, Regan Spring 2012 Cal Poly, Team 12-38, Regan Spring 2012 的会员

CPSU-REGAN-S12S12G38

4 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 6

总计 1,014