简介

This guide is to be used to install the wrist strap holder in the case that the holder becomes damaged or no longer functioning properly due to overuse. A Phillips screwdriver will be needed to complete this installation.

配件

无需配件。

  1. Remove the wrist strap from the wrist strap holder by untying the string at the end of the wrist strap.
    • Remove the wrist strap from the wrist strap holder by untying the string at the end of the wrist strap.

      • This will allow for the wrist strap to be pulled through the wrist strap holder.

  2. Using the thumb, firmly push the Battery/SD cover in the middle and in the direction of the arrow on the Battery/SD cover.
    • Using the thumb, firmly push the Battery/SD cover in the middle and in the direction of the arrow on the Battery/SD cover.

      • This will cause the Battery/SD cover to pop open.

  3. 所有超过US$100.00或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  4. Use the Phillips screwdriver to remove the four screws on the bottom of the camera.
    • Use the Phillips screwdriver to remove the four screws on the bottom of the camera.

  5. Using fingers, pull the silver side panels from each side.
    • Using fingers, pull the silver side panels from each side.

  6. On the right hand side of the camera, remove the two screws from the wrist strap handle by using the Phillips screwdriver.
    • On the right hand side of the camera, remove the two screws from the wrist strap handle by using the Phillips screwdriver.

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Patty Richeson

于2013年03月11日注册

75 信誉积分

创作了4篇指南

团队

Clemson, Team 12-5, Benson Spring 2013 Clemson, Team 12-5, Benson Spring 2013 的会员

CLEM-BENSON-S13S12G5

4 名成员

创作了7篇指南

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 429