简介

If your front casing has come loose or needs to be replaced, follow this guid to remove your current front casing from the camera.

配件

无需配件。

On the bottom right of the camera, locate the battery flap switch.
  • On the bottom right of the camera, locate the battery flap switch.

添加评论

Move this switch to the right so the battery flap can flip open.
  • Move this switch to the right so the battery flap can flip open.

添加评论

  • Slide the orange switch to the right as shown. Now the battery can be pulled out. Reverse these steps to re-install.

添加评论

  • Remove the three 3x3mm screws attached to the rear casing.

添加评论

  • The panel can be identified by the wifi logo on its upper half on the camera's side.

  • Remove the 5x3mm screw holding down the panel on the side closest to the lens.

添加评论

  • Pry the panel off from the bottom using your fingernail.

添加评论

  • Remove the 3x2mm screw underneath the panel near the top of the camera.

添加评论

  • Remove the 4x3mm on the opposite side near the selector wheel.

  • Remove the 2x2mm and 3x2mm screws underneath the a/v flap.

添加评论

  • Pry the back panel away from the body of the camera, using the space you just opened up.

  • Be careful not to damage the ribbon cable on the opposite end of the camera.

  • A small piece of the frame of the camera may fall off, but it can be easily put back into place during reassembly.

添加评论

  • Pry up the plastic ribbon connectors on the body of the camera to release the ribbon cables.

  • The center connector is detached by flipping the black latch up and away from the center of the camera.

  • The smaller connector is detached by flipping the tan latch up and away from the edge of the camera.

添加评论

  • Remove the three 3x3mm screws that attach the front casing to the bottom.

添加评论

  • Remove the two 3x2 screws and two 3.5x2.5 screws attaching the rear panel to the motherboard.

添加评论

  • Lift the back panel off the motherboard.

  • Be careful not to damage the ribbon cable that attaches the mother board to the rear panel.

添加评论

  • Detach the ribbon cable from the motherboard by flipping up the latch on the ribbon connector.

  • Note that the white ribbon connector latch flips away from the ribbon cable.

添加评论

  • Remove the final 4x3mm screw at the top of the camera near the lens.

添加评论

  • Pry the front casing away from the body of the camera.

  • Be careful not to damage the wires that attach the front panel to the motherboard.

  • Short the leads on the capacitor near the flash to avoid a nasty shock when separating the casing from the body.

添加评论

  • Unscrew the three 3x2mm screws that attach the cables to the front casing.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Bryan Bell

于2012年01月26日注册

28 信誉积分

撰写一个指南

团队

Cal Poly, Team 9-5, Regan Winter 2012 Cal Poly, Team 9-5, Regan Winter 2012 的会员

CPSU-REGAN-W12S9G5

5 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 2

总计 1,024