简介

installing the front speaker

Using two fingers, push up on the rear cover. Using two fingers, push up on the rear cover.
  • Using two fingers, push up on the rear cover.

添加评论

The rear cover slides up and off.
  • The rear cover slides up and off.

添加评论

Using the plastic opening tools, pry the left bottom corner of the battery up.
  • Using the plastic opening tools, pry the left bottom corner of the battery up.

添加评论

Pull the battery up and out.
  • Pull the battery up and out.

添加评论

Remove the two Torx T5 screws.
  • Remove the two Torx T5 screws.

  • Remove the one Philips #00 screw.

#0 Phillis screw

skuhry - 回复

Using the plastic opening tool, pry up the battery housing upwards. Push pry tool down, undoing the plastic tab.
  • Using the plastic opening tool, pry up the battery housing upwards.

  • Push pry tool down, undoing the plastic tab.

添加评论

Mac RAM 套件
加速你的Mac。充分利用它的内存。
Mac RAM 套件
从Mac中清理出更多内存。
Pry the upper left tab open on the battery housing. Pry the upper left tab open on the battery housing.
  • Pry the upper left tab open on the battery housing.

添加评论

Pry the top tab of the battery housing. Pry the top tab of the battery housing.
  • Pry the top tab of the battery housing.

添加评论

Pry the right side tab of the battery housing. Pry the right side tab of the battery housing.
  • Pry the right side tab of the battery housing.

添加评论

Pull up on the battery housing. Slide the battery housing out to remove it.
  • Pull up on the battery housing.

  • Slide the battery housing out to remove it.

添加评论

Insert the spudger under the connector. Push the spudger up and twist to release the connector.
  • Insert the spudger under the connector.

  • Push the spudger up and twist to release the connector.

  • Repeat for the next connector.

添加评论

Push on the USB port to expose the black connector. Use the spudger to pry the connector upwards. Use the spudger to pry the connector upwards.
  • Push on the USB port to expose the black connector.

  • Use the spudger to pry the connector upwards.

The philips screw holding down the logic board (at the lower right corner in the picture) has to be removed before the board can be pushed back.

Mark - 回复

Place the spugder under the antenna connector. Pry connector up vertically.
  • Place the spugder under the antenna connector.

  • Pry connector up vertically.

添加评论

Insert the spudger into tab above the camera. Slide upwards until the board detaches from the case. Slide upwards until the board detaches from the case.
  • Insert the spudger into tab above the camera.

  • Slide upwards until the board detaches from the case.

A philips screw holding down the upper logic board (in the lower left corner of the picture) must be remobed before the board can be detached.

Mark - 回复

Press the pointed tip of the spudger into the space below the button assembly.
  • Press the pointed tip of the spudger into the space below the button assembly.

  • Wiggle the spudger tip towards the outside of the button.

  • The button assembly is under some tension and may fly off.

添加评论

Push the pointed tip of the spudger into the base of the side button board.
  • Push the pointed tip of the spudger into the base of the side button board.

  • Lift up, the board will disconnect from the case.

添加评论

Push on the lower motherboard until it slides under the case support. The motherboard assembly comes out as a single piece. Save the small black rubber rectangular sound guide under the motherboard, to replace over the microphone.
  • Push on the lower motherboard until it slides under the case support.

  • The motherboard assembly comes out as a single piece.

  • Save the small black rubber rectangular sound guide under the motherboard, to replace over the microphone.

Be carefull not to tear the home button cable that is in the top right corner!!

zack - 回复

Using the spudger, pop up the end of the speaker.
  • Using the spudger, pop up the end of the speaker.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Niklas Johnson

于2012年01月31日注册

1,063 信誉积分

创作了18篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 2,198