1. Place the monitor face down on a clean, flat surface.
    • Place the monitor face down on a clean, flat surface.

    添加评论

  2. Firmly remove the back panel of the stand by pulling it up and away from the monitor.
    • Firmly remove the back panel of the stand by pulling it up and away from the monitor.

    添加评论

    • Unscrew the two 6mm Phillips PH2 screws to detach the stand enclosure from the stand.

    添加评论

    • Firmly grasp the stand enclosure with your hand and slide it to base of stand.

    添加评论

    • Unscrew the two 14.5mm Phillips PH2 screws holding the stand to the monitor.

    添加评论

    • Lift the the stand straight up to remove it.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Place the monitor screen face up.

    • Pull the frame off by placing your fingers on the inside of the frame and pulling out and up, the frame should snap off.

    • Continue your way around the screen.

    添加评论

    • Unscrew the two 7mm screws from the bottom of the button assembly.

    • Do not pull the button assembly out too quickly or with too much force! Damage to the wires can occur.

    • Pull the button assembly out a few inches and unplug the colored cables.

    添加评论

    • Unscrew the gold colored 7mm Phillips PH000 screw holding the button assembly to the monitor.

    • Remove the button assembly from the monitor.

    添加评论

    • With the monitor face-down, unscrew the 5 7mm Phillips PH2 screws around the outside of the enclosure.

    添加评论

    • Unscrew the 2 14.5mm Phillips PH2 screws located on the raised center of the enclosure.

    • Carefully pull the enclosure off the monitor.

    添加评论

    • Unscrew the 10 5mm Philips PH2 screws holding the metal casing to the monitor.

    添加评论

    • Pull the the metal casing off of the monitor to reveal the motherboards.

    添加评论

    • Carefully insert the prying tool underneath the power supply fuse.

    • Using the prying tool, lift the power supply fuse out of its emplacement until it is resting on its clamps.

    添加评论

    • Carefully remove the power supply fuse by hand.

    添加评论

    • Place the replacement power supply fuse on the fuse clips.

    • With a finger, press down on the ends of the replacement fuse until it is properly seated in the fuse clips.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Drew Troxell

于2013年10月18日注册

113 信誉积分

撰写一个指南

团队

Cal Poly, Team 11-36, Amido Fall 2013 Cal Poly, Team 11-36, Amido Fall 2013 的会员

CPSU-AMIDO-F13S11G36

5 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 4

总计 451