简介

If pulling the trigger of your Nerf Nite Finder doesn't cause it to fire, the trigger might need to be replaced. This guide shows how to do so.

==CAUTION==

Be aware of springs under compression. Take care so these small parts do not fly off the blaster and get lost.

配件

无需配件。

  1. Place the blaster upside down on the table, and remove the screw in the bottom of the handle.
    • Place the blaster upside down on the table, and remove the screw in the bottom of the handle.

    • Remove the battery door and take the batteries out.

  2. Set the blaster on its side with the screws facing up (the blaster will be placed on its left side).  Remove all 14 phillips head, 8.2 mm screws and set them aside. Lift the side of the blaster off exposing its internal parts. Lift the side of the blaster off exposing its internal parts.
    • Set the blaster on its side with the screws facing up (the blaster will be placed on its left side). Remove all 14 phillips head, 8.2 mm screws and set them aside.

    • Lift the side of the blaster off exposing its internal parts.

  3. 所有超过US$100.00或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店

    善于维修,即天赋异禀。

    与 #ImAGenius 分享您的维修故事

    我们都是天才

    与 #ImAGenius 分享您的维修故事

  4. Remove the phillips head, 10.2 mm screw holding the trigger in place. Remove the phillips head, 10.2 mm screw holding the trigger in place.
    • Remove the phillips head, 10.2 mm screw holding the trigger in place.

  5. Remove the trigger by pulling the piece straight up.
    • Remove the trigger by pulling the piece straight up.

    • Caution: Do not let the spring fly off the spring

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Kyle Schober

于2014年02月24日注册

622 信誉积分

创作了5篇指南

团队

Michigan Tech, Team 5-8, Lauer Spring 2014 Michigan Tech, Team 5-8, Lauer Spring 2014 的会员

MTU-LAUER-S14S5G8

3 名成员

创作了9篇指南

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 12

总计 1,066