简介

This replacement guide is useful for someone who needs to replace a damaged rear derailleur for a Mt Fury Roadmaster.

  1. Flip the bicycle upside down so that the bicycle rests on the seat and handlebars. The bike should be able to stay standing on its own.
    • Flip the bicycle upside down so that the bicycle rests on the seat and handlebars. The bike should be able to stay standing on its own.

    添加评论

  2. Locate and remove the main axle nuts (both sides) with a 15mm open-end wrench.
    • Locate and remove the main axle nuts (both sides) with a 15mm open-end wrench.

    添加评论

    • Pull the chain slack and remove the tire.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Locate and remove the rear phillips head screw on the sprocket to remove one side of chain guard.

    添加评论

    • Rotate the derailleur arm forward to access the phillips head screw from the forwardmost sprocket. Remove the screw.

    • Be careful to hold the chain guard in place so the sprocket and washers don't fall out. (Chain guard is highlighted in red).

    添加评论

    • Locate and loosen the hex bolt that clamps the shifting cable.

    添加评论

    • Remove mounting screw that attaches the derailleur to the bicycle frame.

    添加评论

    • Loosen the shifting cable tension adjustment nut and remove the cable from the derailleur assembly .

    添加评论

结论

To install new derailleur, follow these instructions in reverse order.

3等其他人完成本指南。

Monty Dodge Jr

于2014年01月22日注册

474 信誉积分

创作了2篇指南

团队

Cal Poly, Team 1-40, Maness Winter 2014 Cal Poly, Team 1-40, Maness Winter 2014 的会员

CPSU-MANESS-W14S1G40

4 名成员

创作了5篇指南

Directions are simple clear and to the point. Excellent!

Paul J. Baker - 回复

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 7

过去的30天: 22

总计 3,704