跳转到主内容

简介

Before proceeding with the replacement guide, please ensure the headphones are unplugged from any device.

  1. Remove leather headphone cushion by pulling edge towards middle of headphone.
    • Remove leather headphone cushion by pulling edge towards middle of headphone.

    • It should slip off the device.

  2. Carefully peel back foam pad to prevent tearing.
    • Carefully peel back foam pad to prevent tearing.

    • It is glued at both the top and bottom.

  3. Use the T6 torx screwdriver to remove the three screws holding the speaker in place.
    • Use the T6 torx screwdriver to remove the three screws holding the speaker in place.

    • To avoid stripping screws, be sure to use the right screw bit oriented perpendicular to the face of the screw.

  4. With the speaker removed from the speaker module, clip the black and white wires on the back of the speaker, as shown.
    • With the speaker removed from the speaker module, clip the black and white wires on the back of the speaker, as shown.

    • Solder wires onto corresponding pads of replacement speaker.

    • For soldering see the ifixit soldering guide: 如何焊接和拆焊

结论

To reassemble your device, follow these instructions in reverse order.

John Ware

于2014年02月24日注册

325 信誉积分

创作了2篇指南

团队

Michigan Tech, Team 5-1, Lauer Spring 2014 Michigan Tech, Team 5-1, Lauer Spring 2014 的会员

MTU-LAUER-S14S5G1

2 名成员

创作了3篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 232