跳转到主内容

修复你的物品

维修的权力

配件 & 工具

简介

This guide shows how to replace the logic board.

  1. Remove the battery cover by pushing down the release lever at the top of the phone while prying off the cover. Set the cover aside. Set the cover aside.
    • Remove the battery cover by pushing down the release lever at the top of the phone while prying off the cover.

    • Set the cover aside.

  2. Remove the battery by grabbing it near the bottom and lifting out. Remove the battery by grabbing it near the bottom and lifting out.
    • Remove the battery by grabbing it near the bottom and lifting out.

  3. Unscrew four corner screws with T6 screwdriver. Note: The two top screws are short and silver.  The two bottom screws are black and long.
    • Unscrew four corner screws with T6 screwdriver.

    • Note: The two top screws are short and silver. The two bottom screws are black and long.

  4. 任天堂 Switch 套装

    快速恢复到游戏的状态

    购买 Switch 套装

    任天堂 Switch 套装

    快速恢复到游戏的状态

    购买 Switch 套装
  5. Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift. Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift. Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift.
    • Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift.

  6. Starting from left side of phone, remove side buttons and place aside. Note: There should be three buttons. One on each side, and the top. Return phone to starting orientation when done.
    • Starting from left side of phone, remove side buttons and place aside.

    • Note: There should be three buttons. One on each side, and the top.

    • Return phone to starting orientation when done.

  7. Gently remove orange ribbon cable by prying up with spudger. Gently remove orange ribbon cable by prying up with spudger. Gently remove orange ribbon cable by prying up with spudger.
    • Gently remove orange ribbon cable by prying up with spudger.

  8. Use a spudger to pry up logic board by wedging in between logic board and chassis and lifting. Note: Orange ribbon cable is fragile and can be broken.
    • Use a spudger to pry up logic board by wedging in between logic board and chassis and lifting.

    • Note: Orange ribbon cable is fragile and can be broken.

结论

To reassemble your device, follow these instructions in reverse order.

Eric Freeman

于2010年01月26日注册

1 信誉积分

创作了7篇指南

团队

Cal Poly, Team 8-48, Regan Winter 2010 Cal Poly, Team 8-48, Regan Winter 2010 的会员

CPSU-REGAN-W10S8G48

4 名成员

创作了13篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 1,772