简介

This guide describes how to replace the button key board, or the processor that interprets key pad information.

Remove battery cover by pushing down release lever at top of phone while prying off cover.
  • Remove battery cover by pushing down release lever at top of phone while prying off cover.

  • Set cover aside.

添加评论

Remove battery by grabbing it near the bottom and lifting out.
  • Remove battery by grabbing it near the bottom and lifting out.

添加评论

  • Unscrew four corner screws with T6 screwdriver.

    • Note: The two top screws are short and silver. The two bottom screws are black and long.

添加评论

  • Use a spudger to gently pry off back chassis. Wedge the spudger in crevice between back panel and phone and lift.

添加评论

  • Starting from left side of phone, remove side buttons and place aside.

    • Note: There should be three buttons. One on each side, and the top.

  • Return phone to starting orientation when done.

添加评论

  • Gently remove orange ribbon cable by prying up with spudger.

添加评论

  • Use a spudger to pry up logic board by wedging in between logic board and chassis and lifting.

    • Note: Orange ribbon cable is fragile and can be broken.

添加评论

  • Insert spudger under button board and gently lift, set aside.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Eric Freeman

于2010年01月26日注册

1 信誉积分

创作了13篇指南

团队

Cal Poly, Team 8-48, Regan Winter 2010 Cal Poly, Team 8-48, Regan Winter 2010 的会员

CPSU-REGAN-W10S8G48

4 名成员

创作了13篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 1,278