简介

This guide is for removing the phone's earpiece speaker.

  1. Using a spudger, remove the four rubber covers from over the screws.
    • Using a spudger, remove the four rubber covers from over the screws.

    添加评论

  2. Unscrew the cover screws using the T6 bit
    • Unscrew the cover screws using the T6 bit

    添加评论

    • Loosen and remove the cover with a plastic opening tool.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Gently loosen the protective cover with the plastic opening tool.

    Do not pry from the top or bottom of the metal cover. There are a pair of 1/4" long openings on either side of the metal cover at the midpoint of the case. The plastic teeth which lock into the openings must be withdrawn. I used the point of cuticle sissors to get behind the metal strip under each tooth and pull outwards a small distance to release each tooth. The sides of the cover will spring up.

    Fonce - 回复

    • Carefully remove the protective cover from the circuitry

    • Slowly peel the black rubber gasket up off the circuit board.

    • Carefully move the camera out of the way using your hand.

    • Use a flat tool to separate the connection between the upper and lower circuit boards.

    添加评论

    • Gently slip the copper strip out from under the circutry by hand.

    添加评论

    • Pry out the speaker using your fingers.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

gregatron

于2009年10月29日注册

72 信誉积分

创作了6篇指南

团队

Cal Poly, Team 6-6, Maness Fall 2009 Cal Poly, Team 6-6, Maness Fall 2009 的会员

CPSU-MANESS-F09S6G6

4 名成员

创作了12篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 2

总计 2,586