Motorola Moto G Power (2020) Fingerprint Sensor Replacement

简介

This is a guide to replace the fingerprint sensor on the Moto G Power (2020). Follow these simple steps for a successful repair! If you encounter other issues, refer to our troubleshooting page.

Before you begin, download the Rescue and Smart Assistant app. This will allow you to back up your device and determine if your problem is software or hardware-related.

步骤 1 Back Panel

Motorola Moto G Power (2020) Fingerprint Sensor Replacement, Back Panel: 步骤 1 中的图像 1，1

Place a suction cup on the back of the device.
Then open up the back of the device by sliding the opening pick into both sides of the phone.
Do not remove the back panel completely; you must disconnect the fingerprint sensor first.

编辑

步骤 2

Put pressure on the fingerprint sensor with your finger to detach it from the back panel.
You may have to use significant force to get the circular sensor off the panel.

编辑

步骤 3

Completely remove the back panel from the device.

编辑

步骤 4 Fingerprint Sensor

Motorola Moto G Power (2020) Fingerprint Sensor Replacement, Fingerprint Sensor: 步骤 4 中的图像 1，1

Using a Torx T3 screwdriver, remove nine 2.2 mm screws.

编辑

步骤 5

Motorola Moto G Power (2020) Fingerprint Sensor Replacement: 步骤 5 中的图像 3，3

Use the spudger to gently lift the cover.
If needed, use the spudger's tip against a corner of the cover to help lift it.
Set the back cover aside.
DO NOT use excessive force when lifting up the back cover.

编辑

步骤 6

Carefully use the spudger to lift the sensor cable, disconnecting the fingerprint sensor from the motherboard.
WARNING: Handle the sensor cable with care; it can be easily damaged.

编辑