跳转到主内容

修复你的物品

维修的权力

配件 & 工具

简介

Use this guide to replace the vibrator in your Motorola Droid Turbo.

  1. Prepare an iOpener and lay it over the rear case to soften the adhesive on securing the rear case to the phone.
    • Prepare an iOpener and lay it over the rear case to soften the adhesive on securing the rear case to the phone.

  2. Use a plastic opening tool to pry the rear case off of the rest of the device. Remove the rear case.
    • Use a plastic opening tool to pry the rear case off of the rest of the device.

    • Remove the rear case.

    • The wireless charging coil may try to stick to the rear case, so make sure to remove it from the case before fully separating the rear case from the rest of the device.

  3. Manta 螺丝刀工具包

    112 bits for every fix.

    Upgrade Your Toolbox

    Manta 螺丝刀工具包

    Upgrade Your Toolbox
  4. Remove the midframe bezel.
    • Remove the midframe bezel.

  5. Remove the four Torx T5 screws securing the midframe plate.
    • Remove the four Torx T5 screws securing the midframe plate.

  6. Remove the midframe.
    • Remove the midframe.

  7. Use the pointed end of a spudger to gently pry the vibrator up and away from the midframe. Use the pointed end of a spudger to gently pry the vibrator up and away from the midframe.
    • Use the pointed end of a spudger to gently pry the vibrator up and away from the midframe.

结论

To reassemble your device, follow these instructions in reverse order.

Geoff Wacker

于2013年09月30日注册

81,043 信誉积分

创作了89篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 3

总计 1,096