跳转到主内容

简介

Use this guide to replace the dual LED flash board in your Motorola Droid Turbo.

  1. Prepare an iOpener and lay it over the rear case to soften the adhesive on securing the rear case to the phone.
    • Prepare an iOpener and lay it over the rear case to soften the adhesive on securing the rear case to the phone.

  2. Use a plastic opening tool to pry the rear case off of the rest of the device. Remove the rear case.
    • Use a plastic opening tool to pry the rear case off of the rest of the device.

    • Remove the rear case.

    • The wireless charging coil may try to stick to the rear case, so make sure to remove it from the case before fully separating the rear case from the rest of the device.

  3. Use a Jimmy to separate the dual LED flash board from the rear case. The board is secured with some light adhesive, so some force may be required.
    • Use a Jimmy to separate the dual LED flash board from the rear case.

    • The board is secured with some light adhesive, so some force may be required.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Geoff Wacker

于2013年09月30日注册

78,274 信誉积分

创作了89篇指南

Gostaria se possível alguem tenha o manual de serviço do Moto maxx XT 1225 ou 1254. Porf favor , ddani8260@gmail.com

Daniel Gomes - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 7

总计 756