简介

This guide will take you though the process of replacing a faulty or non-functioning speaker in your Motorola Droid.

配件

无需配件。

Slide the battery cover downwards while applying pressure to the center of the battery cover with your thumb.
  • Slide the battery cover downwards while applying pressure to the center of the battery cover with your thumb.

  • Lift and remove the battery cover out from the phone.

添加评论

Grasp the upper left corner of the battery and lift it out of its housing.
  • Grasp the upper left corner of the battery and lift it out of its housing.

添加评论

  • Use a spudger to lift and remove the black plastic screw cover at the top of the phone near the camera.

  • The cover is attached by adhesive, so some force may be required.

This is actually extremely difficult to do with the plastic spudger pictured. I was forced to use the thin sharp tip on a metal spudger to get any leverage, which slightly damages the plastic.

Robert Ciaccio - 回复

  • Using the tip of a spudger, peel up one corner of the gold ribbon beneath the battery compartment.

  • Peel the ribbon up off the phone.

添加评论

  • Carefully peel the device information label that covers the motherboard EMI shields.

  • This label contains important information specific to the phone. Remove it with care and keep it in a safe place.

添加评论

  • Insert the flat end of a spudger and pry the plastic camera cover up off the phone.

  • The thin plastic cover is attached to the phone with an adhesive. Work slowly and carefully.

添加评论

  • Remove the seven 5.5 mm T5 Torx screws securing the rear case to the inner case.

添加评论

  • Insert the flat end of a spudger and pry downwards to release the plastic tab holding the rear case to the motherboard screw.

添加评论

  • Gently insert a spudger between the rear case and front case at the top of the phone, near the audio jack.

  • Carefully pry the top edge of the rear case up from the rest of the phone.

添加评论

  • With the spudger still inserted between the rear case and front case, slide the spudger along the right edge of the device, moving toward the bottom, prying as you go.

  • Continue prying along the bottom edge of the device from right to left, freeing it from the front panel.

添加评论

  • Continue prying the rear case from the front case along the left side, moving from bottom to top.

  • Lift the rear case up out of the phone.

添加评论

  • Carefully lift and remove the speaker assembly up out of the phone.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Matthew Newsom

于2010年01月05日注册

31,789 信誉积分

创作了67篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 14

总计 16,558