简介

This guide will take you though the process of replacing a faulty or non-functioning speaker in your Motorola Droid 2.

配件

无需配件。

Slide the battery cover toward the bottom edge of the phone.
  • Slide the battery cover toward the bottom edge of the phone.

  • Remove the battery cover from the rear of the phone.

添加评论

Lift the battery out of the Droid 2 from the edge closest to the bottom of the phone.
  • Lift the battery out of the Droid 2 from the edge closest to the bottom of the phone.

  • Remove the battery from the Droid 2.

添加评论

  • Using the tip of a spudger, peel up one corner of the silver ribbon below the battery compartment.

  • Peel the ribbon off the phone.

添加评论

  • Insert the flat end of a spudger and pry the plastic camera cover up off the phone.

  • The thin plastic cover is attached to the phone with an adhesive. Work slowly and carefully.

添加评论

  • Use the tip of a spudger to remove the camera bezel stuck to the rear case.

添加评论

  • Remove the seven 5.5 mm T5 Torx screws securing the rear case to the inner case.

添加评论

  • Insert the flat end of a spudger and pry downwards to release the plastic tab holding the rear case to the motherboard screw.

添加评论

  • Gently insert a spudger between the rear case and front case at the top of the phone, near the audio jack.

  • Carefully pry the top edge of the rear case up from the rest of the phone.

添加评论

  • With the spudger still inserted between the rear case and front case, slide the spudger along the right edge of the device, moving toward the bottom, prying as you go.

  • Continue prying along the bottom edge of the device from right to left, freeing it from the front panel.

添加评论

  • Continue prying the rear case from the front case along the left side, moving from bottom to top.

  • Lift the rear case up out of the phone.

  • At this point, the button covers on the side of the phone are free and may fall out if you tip the phone upside down.

添加评论

  • Carefully lift the speaker/antenna assembly up and out of the phone.

  • If you are re-assembling your phone, insert any power, camera, or volume buttons that may have fallen out at this point.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

3等其他人完成本指南。

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 6,806