简介

This guide requires minimal teardown and can be used to replace the plastic back case of the device.

配件

无需配件。

  1. Remove the battery by sliding it down the rails to which it is connected.
    • Remove the battery by sliding it down the rails to which it is connected.

    添加评论

  2. Find a flat head or Phillips head screwdriver.
    • Find a flat head or Phillips head screwdriver.

    • Insert the screwdriver into the holes in the plastic rod connecting the key pad guard to the rear casing.

    • Use the screwdriver to push the rods towards each other until they click out of their locked position.

      • Note: This may require a large amount of force.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Slide off the antenna guard and locate the four clips on the exterior of the rear casing.

    • Simultaneously push the clips outward while lifting the old rear casing away from the rest of the device.

    添加评论

    • Locate the four holes on the new rear casing.

    • Align the holes in the new rear casing with the clips attached the to front casing.

    • Simultaneously insert all four clips.

    • Push down firmly until you hear the clips click into place.

    添加评论

    • Find a thin and sturdy screwdriver.

    • Insert the screwdriver into the holes in the plastic rod connecting the new key pad guard to the rear casing.

    • Use the screwdriver to push the rods away from each other until they click into their locked position.

      • Note: This may require a large amount of force.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Andrew Lam

于2012年04月17日注册

28 信誉积分

创作了4篇指南

团队

Cal Poly, Team 9-46, Regan Spring 2012 Cal Poly, Team 9-46, Regan Spring 2012 的会员

CPSU-REGAN-S12S9G46

5 名成员

创作了8篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 3

总计 832