简介

This guide will help locate the motherboard for removal and/or repair.

  1. Flip over the phone and then slide down the back cover with your thumb.
    • Flip over the phone and then slide down the back cover with your thumb.

  2. Lever out the battery from the phone using your thumb.
    • Lever out the battery from the phone using your thumb.

  3. Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment. Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment.
    • Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment.

  4. 所有超过US$100.00或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店

    Ever fixed something? That’s Genius.

    Share your repair story with #ImAGenius

    We Are All Geniuses

    Share your repair story with #ImAGenius

  5. Gently pull off hinge cap piece from the the top of the phone.
    • Gently pull off hinge cap piece from the the top of the phone.

  6. Using a T6 Torx Screwdriver, remove the four 7.62mm screws around the corners of the battery compartment.
    • Using a T6 Torx Screwdriver, remove the four 7.62mm screws around the corners of the battery compartment.

  7. Open the phone and turn it on its side. Using a plastic opening tool, run along the seam located around the sides of the phone to pop the clips holding the casing to the frame.
    • Open the phone and turn it on its side.

    • Using a plastic opening tool, run along the seam located around the sides of the phone to pop the clips holding the casing to the frame.

  8. Using your hand, gently pull of the back panel from the bottom half of the phone.
    • Using your hand, gently pull of the back panel from the bottom half of the phone.

  9. Close the phone and place it on a flat surface.
    • Close the phone and place it on a flat surface.

    • Using a plastic opening tool or your finger, lift up the motherboard from the bottom casing.

    • Be careful when pulling up the board, as there is still a ribbon cable attached to the back of the board.

  10. On the underside of the motherboard, find the ribbon cable that attaches the board to the rest of the phone.
    • On the underside of the motherboard, find the ribbon cable that attaches the board to the rest of the phone.

    • Using a plastic opening tool, slowly detach the ribbon cable connector, then pull the motherboard away from the frame.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Andrew

于2010年10月04日注册

361 信誉积分

创作了4篇指南

团队

Cal Poly, Team 4-46, Amido Fall 2010 Cal Poly, Team 4-46, Amido Fall 2010 的会员

CPSU-AMIDO-F10S4G46

4 名成员

创作了14篇指南

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 3

总计 203