简介

Installing a new back panel in this television is straightforward and requires minimal disassembly.

  1. Before disassembling your television, be sure it is powered off and unplugged.
    • Before disassembling your television, be sure it is powered off and unplugged.

    • Remove the single 18 mm Phillips #1 screw on the lamp access panel.

    添加评论

  2. Pull the lamp access panel off of the back panel of the television by pulling straight back on the left side of the panel near the screw then pulling to the left.
    • Pull the lamp access panel off of the back panel of the television by pulling straight back on the left side of the panel near the screw then pulling to the left.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Loosen the two Phillips #2 screws securing the lamp housing to the television until the screws will swivel vertically.

      • These two screws are permanently attached to the lamp housing and cannot be removed completely.

    添加评论

    • Using the handle, pull the lamp housing straight back out of the television.

      • Do not touch the glass of the lamp with your bare hands. The oil from your fingers can distort the TV image and lead to other issues.

    添加评论

    • Remove the following 8 Phillips #1 screws:

      • One 22 mm Phillips #1 in the bottom right corner of the back panel.

      • One 18 mm Phillips #1 in the top middle of the back panel.

      • Six 18 mm Phillips #1 in the rest of the back panel.

    添加评论

    • Pull the back panel off of the television by gripping the sides and rotating it down.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Herman Chai

于2012年10月02日注册

172 信誉积分

创作了3篇指南

团队

Cal Poly, Team 18-39, Regan Fall 2012 Cal Poly, Team 18-39, Regan Fall 2012 的会员

CPSU-REGAN-F12S18G39

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 2

过去的30天: 9

总计 753