简介

The flashbulb and casing are one component located at the top of the camera. A replacement will be the whole component and not each of the parts separately.

配件

无需配件。

Locate and remove the silver screws on each side of the camera. Use the Phillips #00 Screwdriver to unscrew all 2.0mm (4 instances) and 4.0mm (2 instances) screws. Use the Phillips #00 Screwdriver to unscrew all 2.0mm (4 instances) and 4.0mm (2 instances) screws.
  • Locate and remove the silver screws on each side of the camera.

  • Use the Phillips #00 Screwdriver to unscrew all 2.0mm (4 instances) and 4.0mm (2 instances) screws.

添加评论

Then, carefully pry apart the front and back outer casing away from the internal components. Be aware of the ribbon wire that will disconnect when the casing is detached. Be aware of the ribbon wire that will disconnect when the casing is detached.
  • Then, carefully pry apart the front and back outer casing away from the internal components.

  • Be aware of the ribbon wire that will disconnect when the casing is detached.

添加评论

Mac RAM 套件
加速你的Mac。充分利用它的内存。
Mac RAM 套件
从Mac中清理出更多内存。
Remove 2mm screws connecting the flash housing to the main components of the camera. Use a Philips #00 screwdriver to remove the black 2.0mm (4 instances) screws .
  • Remove 2mm screws connecting the flash housing to the main components of the camera.

  • Use a Philips #00 screwdriver to remove the black 2.0mm (4 instances) screws .

添加评论

Use the spudger to push the black plastic hooks through the circuit board to release the flash housing. Once the screws have been removed, pull the circuit board away from the body of the camera. Wires will keep it from completely detaching.
  • Use the spudger to push the black plastic hooks through the circuit board to release the flash housing.

  • Once the screws have been removed, pull the circuit board away from the body of the camera.

  • Wires will keep it from completely detaching.

  • Pull the housing away from the circuit board.

添加评论

结论

To reassemble device, follow steps in reverse order. This will require the reattachment of wires from the camera to the flashbulb casing.

Keith Sechrist

于2013年03月11日注册

22 信誉积分

创作了2篇指南

团队

Clemson, Team 12-4, Benson Spring 2013 Clemson, Team 12-4, Benson Spring 2013 的会员

CLEM-BENSON-S13S12G4

3 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 294