跳转到主内容

Fix Your Stuff

Right to Repair

Parts & Tools

简介

In the event that the flash is not working properly due to internal issues and not settings, it is possible to replace the capacitor to restore function to the flash.

配件

没有特定配件。

  1. Locate and remove the silver screws on each side of the camera. Use the Phillips #00 Screwdriver to unscrew all 2.0mm (4 instances) and 4.0mm (2 instances) screws. Use the Phillips #00 Screwdriver to unscrew all 2.0mm (4 instances) and 4.0mm (2 instances) screws.
    • Locate and remove the silver screws on each side of the camera.

    • Use the Phillips #00 Screwdriver to unscrew all 2.0mm (4 instances) and 4.0mm (2 instances) screws.

  2. Then, carefully pry apart the front and back outer casing away from the internal components. Be aware of the ribbon wire that will disconnect when the casing is detached. Be aware of the ribbon wire that will disconnect when the casing is detached.
    • Then, carefully pry apart the front and back outer casing away from the internal components.

    • Be aware of the ribbon wire that will disconnect when the casing is detached.

  3. Caution: Touching the capacitor leads may cause serious injury. Use a capacitor discharge probe to safely rid the capacitors of dangerous charges. On the front side of the camera, locate the flash battery holder.
    • Caution: Touching the capacitor leads may cause serious injury. Use a capacitor discharge probe to safely rid the capacitors of dangerous charges.

    • On the front side of the camera, locate the flash battery holder.

    • Lift the housing and remove the battery.

    • After removing the battery, clip the wires and solder the replacement battery.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Qqq

于2013年03月11日注册

19 信誉积分

撰写一个指南

Its a cap not a battery :D

Eigirdas Gedgaudas - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 7

总计 647