修复你的物品 社区 商店

Milwaukee M18 2606-20 Chuck Replacement

简介

If you need to replace the chuck (bit is coming loose from the chuck) on your Milwaukee M18 2606-20 cordless power drill, see this guide on how to remove it. The chuck holds the bits on the drill and over time it could break or not be able to remain tight on a bit. This removal could require a bit of strength so keep this in mind.

你所需要的

  1. Milwaukee M18 2606-20 Chuck Replacement, Chuck: 步骤 1 中的图像 1，3 Milwaukee M18 2606-20 Chuck Replacement, Chuck: 步骤 1 中的图像 2，3 Milwaukee M18 2606-20 Chuck Replacement, Chuck: 步骤 1 中的图像 3，3

    • Rotate the chuck counterclockwise as far as possible to loosen from the base.

    翻译

  2. Milwaukee M18 2606-20 Chuck Replacement: 步骤 2 中的图像 1，2 Milwaukee M18 2606-20 Chuck Replacement: 步骤 2 中的图像 2，2

    • Remove the 28 mm inner screw holding the chuck onto the drill using a Phillips #3 screwdriver.

    • Rotate the screw clockwise to loosen it.

    • The inner chuck screw is reverse threaded which is why it needs to be rotated clockwise.

    翻译

  4. Milwaukee M18 2606-20 Chuck Replacement: 步骤 3 中的图像 1，2 Milwaukee M18 2606-20 Chuck Replacement: 步骤 3 中的图像 2，2

    • Insert an Allen wrench into the chuck and tighten the chuck onto the wrench.

    • The Allen wrench will be used for leverage when removing the chuck.

    • When the chuck is tightened it could make a clicking sound. This is fine and is not causing any harm to the drill.

    翻译

  5. Milwaukee M18 2606-20 Chuck Replacement: 步骤 4 中的图像 1，3 Milwaukee M18 2606-20 Chuck Replacement: 步骤 4 中的图像 2，3 Milwaukee M18 2606-20 Chuck Replacement: 步骤 4 中的图像 3，3

    • Rotate the Allen wrench counterclockwise to remove the chuck.

    翻译
结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

4条评论

Milwaukee say to heat the tort screw up to loosen the locktite. Did this to the second chuck I replaced came off much easier. Getting the chuck off was a different story, tried hitting a 10mm allan key in the chuck didn’t work. Ended up getting a 10mm 1/2’ allan head socket on a breaker bar. Put the drill on the ground stood on it and with the other leg kicked the breaker bar. Came straight off.

tim.karen.collins - 回复

My chuck was stuck and working rough, needed to get it off the drill motor. Worked on a Harbor Freight Hercules 1/2” hammer/drill just fine. Neat trick using the Allen for leverage! Looks a lot like a copy…

Thanks! Dave D.

David Dryden - 回复

Not really clear in what mode it needs to be, nor what rotation mode

Rombout Versluijs - 回复

1st gear and twist the drill threshold to the drill bit setting (max torque).

Dustin Gordon -

添加评论

浏览统计数据:

过去 24 小时： 7

过去 7 天： 54

过去 30 天： 298

总计 17,987