修复你的物品 社区 商店

Manatee V2S Intelligent Clothes Dryer Filter Replacement

简介

Use this guide to clean/replace the air filter on your Manatee V2S Intelligent Clothes Dryer. With a dirty filter, you may experience a loss in performance, and it may make some noise. Be careful of any loose or exposed wires as that also may be an issue. In this guide, we will be using a piece of tape to clean the filter. Make sure the device is completely powered off before taking it apart.

你所需要的

  1. Manatee V2S Intelligent Clothes Dryer Filter Replacement, Filter: 步骤 1 中的图像 1，1

    • Turn the machine upside down.

    编辑

  2. Manatee V2S Intelligent Clothes Dryer Filter Replacement: 步骤 2 中的图像 1，1

    • Use a Phillips #0 screwdriver to remove the 3.5 mm screw holding the bottom case to the device.

    编辑

  4. Manatee V2S Intelligent Clothes Dryer Filter Replacement: 步骤 3 中的图像 1，1

    • Cut out about 10 cm of scotch tape.

    • Turn it over and go around your hand as shown in the image, which lets the adhesive side on the outside. (Because it is easy to remove dust)

    • You can also use any other ways to remove the dust, but make sure not to break the filter.

    编辑

  5. Manatee V2S Intelligent Clothes Dryer Filter Replacement: 步骤 4 中的图像 1，1

    • Take out the filter.

    • Tap the dust and particles into the garbage, remove the dust with scotch tape, or replace the filter.

    编辑

  6. Manatee V2S Intelligent Clothes Dryer Filter Replacement: 步骤 5 中的图像 1，2 Manatee V2S Intelligent Clothes Dryer Filter Replacement: 步骤 5 中的图像 2，2

    • Check for broken/loose wiring and other connections.

    • Dust may not be the only reason for the poor performance.

    • Close the lid and replace the screw.

    编辑
结论

To reassemble your device, follow these instructions in reverse order.

作者

与4其他贡献者

[deleted]

于09/17/21注册

121 声望

撰写一个指南

徽章: 2

0条评论

添加评论

浏览统计数据:

过去 24 小时： 1

过去 7 天： 2

过去 30 天： 15

总计 486