修复你的物品 社区 商店

Maisto Rock Crawler Truck Circuit Board Replacement

简介

This guide will walk you through the process of replacing the truck circuit board in a Maisto Rock Crawler.

你所需要的

  1. Maisto Rock Crawler Truck Circuit Board Replacement, Truck Circuit Board: 步骤 1 中的图像 1，2 Maisto Rock Crawler Truck Circuit Board Replacement, Truck Circuit Board: 步骤 1 中的图像 2，2

    • Flip the R/C truck over.

    • To take off the R/C truck top, use the driver and bit PH2 and remove the four 7.7mm Philips screws highlighted.

    翻译

  2. Maisto Rock Crawler Truck Circuit Board Replacement: 步骤 2 中的图像 1，2 Maisto Rock Crawler Truck Circuit Board Replacement: 步骤 2 中的图像 2，2

    • Half way remove the truck top so you can unhinge the antenna from the clips.

    • Remove the R/C truck top completely.

    翻译

  4. Maisto Rock Crawler Truck Circuit Board Replacement: 步骤 3 中的图像 1，1

    • Use the Driver and bit J1 to remove the top under-body plate by unscrewing the eight 9.5mm Philips screws.

    翻译

  5. Maisto Rock Crawler Truck Circuit Board Replacement: 步骤 4 中的图像 1，1

    • Use the driver and bit J1 and remove the 7.7mm Philips screw highlighted.

    翻译

  6. Maisto Rock Crawler Truck Circuit Board Replacement: 步骤 5 中的图像 1，1

    • Take note of which wire is connected at which pin before desoldering. It might help to mark the wires and take a picture.

    • It would be easier to desolder and resolder only one component at a time.

    • Use the soldering iron to desolder all the wires connected to the circuit board.

    翻译
结论

To reassemble your device, follow these instructions in reverse order.

3等其他人完成本指南。

作者

与3其他贡献者

kevin

于02/10/16注册

874 声望

创作了6篇指南

徽章: 9

+ 6更多徽章

团队

USF Tampa, Team 1-2, Sullivan Spring 2016 USF Tampa, Team 1-2, Sullivan Spring 2016 的会员

USFT-SULLIVAN-S16S1G2

3 名成员

创作了6篇指南

9条评论

Can you do anything to it to make it stronger are powerful

Matt John - 回复

Yes put a board from a nikko or ez tec in it. The 9.6 volt is the one to find and wire the motors to the single motor output. I think u have to wire one backwards to get both going right way

Mike - 回复

My rc car is not responding to left or right signals from remote.

CAN I got any help on this

pankaj kapatia - 回复

Can any one help as my rc rock crawler is not turning left or right

pankaj kapatia - 回复

did you use biger voltage than normal? because it sound like that. i think your’s car has brokened ic-component.

mattilajanne - 回复

添加评论

浏览统计数据:

过去 24 小时： 0

过去 7 天： 10

过去 30 天： 25

总计 5,425